Tower Lifting Tool

For 36 mm holes use 1-1/2” socket head cap screws.
For 45 mm holes use 1-3/4” stepped studs as shown in the example, below.

Wind-Worker™ Tower Tools are designed to fit bolt patterns that are 11-3/4 to 16 in. (center-to-center). Custom sizes are available on request.

The following illustrations depict the tower and tools at varying stages of the lift.

Note: The slings are positioned so they do not overlap.

For loading and unloading operations it is necessary to install both Top and Bottom Lifting Tools to avoid overlapping the slings.

Install Top Lifting Tools at the following positions: 10.5, 1.5, 4.5 and 8.5 O’clock.
Install Bottom Tools at the following positions: 10.5 and
1.5 O’clock.
 

Always install a bolt or stud through a drilled hole before installation through the slotted side. This will keep the tool from sliding back and forth in the slot.

Do not put fingers in holes or slots, under any circumstance. For aligning holes, ADB® recommends the use of a locating pin or similar tool.