Rotating Lift Lugs

Rotating Lift Lugs are used to connect slings to the bottom, side apertures of ISO 668 Container Corner Fittings (ISO 1161).

Rotating Lift Lugs with the Pre-Lift Safety Lock feature prevents unwanted fallout while Lugs are NOT under load. The roof wall of the corner fitting captures the toe to prevent accidental dislodgement, while the Lift Lug body rotates around the toe.

Rotating Lift Lugs fit left or right hand corner fittings and do not require shackles for sling connection. They rotate to any angle; however ISO 1496 does not permit containers to be lifted from the bottom corners at angles less than 30 degrees horizontal. DOL-OSHA does not permit rigging to contact containers. Spreader bars or other means must be utilized to ensure compliance.

Rotating Lift Lugs are Thermal Zinc Coated (similar to hot dip galvanizing) and are proof tested to twice WLL.

Rotating Lift Lug Stock No. RLL-416000C-LSTZW WLL- 33,600 Lbs. Lift Lug Weight-22.3 Lbs. Temperature Range: 120°/-40°(F) Safety Lock Replacement Kit Stock No. SLRK-416005B-1TZK Safety Lock Kit Weight-6.3 Lbs. Rotating Lift Lugs are simple to use: Insert the “Toe”. Twist the Cross Pin 90 degrees to lock and prepare to Lift. Recommended for applications where it is not practical for personnel to ensure that the 90 degree toe interlock in the corner fitting is maintained, prior to lifting.

Lift Lug Users must be trained and knowledgeable in ISO 668, ISO 3874 Bottom Lift Standards and all other, applicable, federal, state, provincial, and maritime standards and regulations. Use by untrained personnel is hazardous and may result in INJURY, DEATH and/or property destruction. DO NOT EXCEED Work Load LIMIT.